Skip to main content

Heathkit C3 Condenser Checker – Wrapup

 

Heathkit C3 Condenser Checker – Wrapup

Filed in C3 Capacitor Tester on Feb.24, 2018

Finally, I just wanted to demonstrate the operation of the C3 Condenser Checker.  I’m not much of a videographer, but here is my video demonstrating the device to check several good and bad capacitors for value and leakage. Enjoy!

 


Comments

Post a Comment

Popular posts from this blog

Building the W8NX Short Trap Dipole

Image
  Building the W8NX Short Trap Dipole Filed in Antennas on May.31, 2021 For the past five years, I have been operating the lower bands (30, 40 and 80 meters) with a trap dipole that was modeled after a web article written by John DeGood NU3E. [1] While the antenna performed well, a monsoon storm last summer beat it up enough that the antenna wire broke at the center balun. So I climbed the tower and lowered the remains of the antenna to the ground for repairs. On closer examination, I discovered that the relentless Arizona sun had taken its toll on the traps. The insulation on the exposed ends of the coax had rotted away. They were still working, but would need to be rebuilt and weatherized to insure good operation many years into the future. Since I was going to have to rebuild the antenna, I started thinking about whether this antenna met my current needs and wishes. I had been wanting to get on 160 meters at this QTH for some time, but my small back yard w...
Read more

Making the Heathkit IG-102 Signal Generator Useful

Image
  Making the Heathkit IG-102 Signal Generator Useful Filed in Kits on Apr.27, 2015 While I am very happy with my homebrew 8640jr signal generator, I’ve had this old IG-102 RF Signal Generator from Heathkit hanging around for a decade or so. I was curious what kind of levels it was capable of, so I dragged it out and hooked it up to the scope to investigate a bit.   Heathkit IG-102 The main problem I have always had with this generator is the connectors on the front for the RF and AF out. They are not commonplace anymore, so replacing them with BNC connectors made sense. Prior to doing this, I always used a coax with alligator clips to connect, which wasn’t very secure. I found a few panel mount BNC connectors in my junk box, and installed them into the same holes as the original connectors.     Back side of BNC Connector installation   Front side BNC Connectors Installed   Now that I could get decent cables on the generator, I started making meas...
Read more

Yaesu G-450XL Rotator Repair

Image
  Yaesu G-450XL Rotator Repair Filed in Antennas on Dec.30, 2007 In December of 2007, the rope support for the center element of my Cushcraft A3 broke, requiring me to climb the tower and bring the beam down for maintenance.  At the same time, at had been noticing that the rotator control was not indicating correctly, it was very erratic.  So I brought the rotator down for maintenance, as well. The first step was to mark the side of the case, where the top and bottom of the clam shells connected together.  This would allow me to assemble it in the correct alignment when the time came.   Marked Case of Rotator Next, I took the top cover off.  All of the bearings between the clam shells in the depression on the outside were safely stored.   Top Removed A little inspection revealed what the problem was.  The center gear had broken away from the shaft it was pressed onto.  I tried re-pressing it back onto the shaft, but it was to...
Read more