Archive for the ‘Heathkit TC-1’ Category

Heathkit TC-1 Tube Checker – Theory of Operation – Quality Check

The Quality Check is the main function of the TC-1 Tube Checker.  In this mode, the tube is connected into the circuit to act as a simple diode.  No effort is made to find how much gain a given tube might have in other configurations.  This is a very basic test of how well the […]

Leave a Comment

Heathkit TC-1 Tube Checker – Theory of Operation – Filament Check

The TC-1 uses a neon bulb to sense relatively higher current flow in the plate circuit of the tube under test.  It uses this function in order to detect short circuits between the various elements of the tube. It uses this same circuitry to test whether a filament has continuity or is open.  To set […]

Leave a Comment

Heathkit TC-1 Tube Checker – Theory of Operation – Line Set Mode

Theory of Operation: Line Set Mode In Line Set Mode, the TC-1 is set up to measure the 115 volt winding of the transformer, and set it to 115 volts, regardless of a variation in the line input voltage.  This allows the checker to give valid go/no-go checks of tube emissions even if the line […]

Leave a Comment

Heathkit TC-1 Tube Tester Restoration Part 10

Part 10: Operational Testing With the TC-1 Tube Checker electrical restoration complete, it was time to run through a few tubes to see how it works… Step 1: Set all controls for startup. Set Line – Center Range Type – 1 Filament – 0.75 Plate 0

Leave a Comment

Heathkit TC-1 Tube Tester Restoration Part 9

Part 9: Cabinet Restoration The cabinet was a little beat up, but not in too bad of condition mechanically.

Leave a Comment